![]() This depends which value you have within your sktop file on line 4: Exec=xscreensaver -nosplash. ![]() On my computer it's in /etc/xdg/autostart/sktop, then open it in an editor (terminal 'nano' may be best as you will need sudo commands to open it) and change 'Applicaton' to 'Application'.Īlso, different tutorials (such as liberiangeek and Radu's response) suggest using: "xscreensaver -nosplash"Īs the fix above uses. This should, somewhere in the list, tell you where sktop is. To find out if this is the issue: first run locate sktop. Into your startup list, it would not work as xscreensaver is not set up with the type application. Therefore, if you have already entered the command "xscreensaver -no-splash" This causes the startup command to not work. 'Application' has been misspelt as 'Applicaton'. However, for some reason, in many of these tutorials, the above command is incorrect. They tell you to set up a sktop file with the following command: sudo gedit /etc/xdg/autostart/sktopĪnd then place inside it the following information: In BSPWM when you are in no active window, appears a cursor with a X shape. And the window of Rambox will be recognized. To prevent this issue, disable this option. When Rambox is configured to start minimized, the window is not recognized by rofi event after being shown. As no answer has been marked as correct yet this could be this issue with running xscreensaver on startupĪs says here, many of the tutorials for setting up xscreensaver provide incorrect information. Trouble: Rambox not shown in rofi windows switcher.
0 Comments
Leave a Reply. |